Chain manufacturer’s chain maintenance

1. Sprocket should be installed on the shaft without skew and swing. The end faces of the two sprockets in the same transmission assembly of the chain manufacturer shall be located in the same plane. When the distance between the sprockets is less than 0.5 meters, a deviation of 1 mm shall be allowed. Sprocket in the distance of more than 0.5 meters, allow a deviation of 2 mm. But does not allow to have the conflict sprocket tooth flank surface phenomenon, if two wheel braided move too large simple generation takes off the chain and accelerate the wear and tear. Take care to check and adjust offsets when replacing sprockets.

2. The tightness of the precise chain manufacturer shall be suitable. If the power is consumed when the chain is too tight, the bearing is easy to wear out; Too loose chain is easy to jump and take off. The tightness of the chain is as follows: lift or press down from the middle of the chain, and the distance between the two sprockets is about 2%-3%.

3, the new chain is too long or after the use of elongation, difficult to adjust, can be removed depending on the situation, but must be an even number. The chain node shall pass through the reverse side of the chain, and the lock plate shall be inserted outside. The opening of the lock plate shall roll in the opposite direction.

4, sprocket wear after serious, should replace the new sprocket and new chain together, in order to ensure excellent meshing. New chains or sprockets cannot be replaced alone. Otherwise it will form meshing less than good acceleration of the new chain or sprocket wear. Sprocket tooth surface wear to a certain degree should be turned over in time to use (refers to the adjustable surface of the use of sprocket), to extend the use of time.

5. The old chain cannot be mixed with some new chains, otherwise it will simply produce impact in the transmission and break the chain.

6. The chain should be filled with lubricating oil in time during operation. Lubricating oil shall enter the fit clearance between roller and inner sleeve to improve working conditions and reduce wear.

Precision chain manufacturer

In the use and maintenance of the chain to pay attention to the following problems:

Before starting the chain, check whether the chain runs normally and whether the saw chain has normal tightness.

Remember to close the chain brake before starting, so that you can brake the chain and avoid danger when starting. But before work to loosen the chain brake, otherwise it will damage the bearing.

Be careful not to collide with the ground or other objects as the chain rolls.

The chain should be timely oil altered anti-rust paint, such as chain rust to replace in time, in order to improve work efficiency.

Always check and protect the chain. Repair the broken chain in time and find out the cause.

 


Post time: Sep-01-2020

WhatsApp Online Chat !